BARIX Streaming Client User Manual download pdf (Page 11)

does not have to get a new IP address at power on or reboot.

IP Address

Enter the 4 values of the desired static IP address e.g.:

• “192.168.0.12” for an internal LAN

Attention: Make sure that you enter a free IP address. The device will check this and will not be

available until the device using the same IP is disconnected or switched off. The command Ping

can be used to ensure that a speciﬁc IP address is unused (i.e. No reply).

The automatic discovery functions are not executed if a Static IP address is set.

The automatic options are as follow:

• “0.0.0.0” for automatic discovery (Discovery order: BOOTP, DHCP, IPzator, AutoIP)

To enable automatic discovery but disable certain IP discovery functions set all but the third value

to zero.

For each function you want to disable add the value from the table below:

• “0.0.1.0” to disable AutoIP

• “0.0.2.0” to disable DHCP

• “0.0.4.0” to disable BOOTP

• “0.0.8.0” to disable IPzator

Examples:

• “0.0.3.0” disables AutoIP and DHCP

• “0.0.11.0” disables all but BOOTP

Attention: “0.0.15.0” disables all discovery functions which locks you out unless you reset the

device to factory defaults by pressing the reset button for about 10 seconds.

Netmask

Enter the 4 values of the desired Netmask e.g.:

• “0.0.0.0” for a default Netmask depending on the IP Address used

• “255.255.255.0” for a C class network

Note: Try ﬁrst the Netmask your PC is set to or ask your Network Administrator.

11 Device Conﬁguration

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 34 35

No comments

BARIX Streaming Client User Manual Page 11