BARIX Streaming Client Installation Guide download pdf (Page 37)

7 IR control interface

When using IR Remote Control, make sure there is line of sight between the IR

Serial receiver and the IR Remote control.

IR Buttons

With the default factory configuration, following buttons can be used:

• +VOL/-VOL – Volume up/Volume down

• +SONG/-SONG – Next song/Previous song (for use with playlists)

• SHUFFLE – Toggles the Shuffle Play Mode

• The digit buttons (0..9) and the Play button () can be used to select channel

number.

• Buttons PLIST+ and PLIST- increase/decrease the channel number by one. To

start playback of the selected channel, the Play button has to be pressed.

• MUTE – Toggles volume mute

• ON/OFF – Toggles the Stand-by mode, see below

Channel Selection

The channel number can be used as a part of the source URL (see chapter 5.2 URL

Variable Substitution for details). The channel number is common for all three

source URLs.

Last three digits pressed within five seconds before pressing  are set (from left to

right) as the channel number.

If less than three digits were pressed within five seconds before , remaining

positions (from left) are filled with the current channel number (reverted).

The channel number can be also selected by pressing PLIST+/PLIST- buttons, which

increase/decrease the channel number. After channel selection, the Play button

MUST be pressed to confirm the selection.

If multiple sources are configured, the Play button () forces playback restart from

URL1 (without checking the actual availability of URL1). This can be useful if a

backup USB stream is playing and the selected channel (higher priority network

stream) is not available – the Play button aborts the USB playback and forces the

network stream to play.

The current channel number is stored in Setup (W293) and retrieved after reboot.

Examples:

• After pressing 2,3, the channel number will be 023

• After pressing 1,4,5,6,7,  the channel number will be 567

• Playing channel 15; after pressing PLIST-, PLIST-,  the channel number will be 13

Stand-by Mode

To reduce network bandwidth usage and decrease associated costs for transferred

data, the device features Stand-by Mode. In this mode the device stops checking

source availability and streaming (including playback from USB source) and goes

idle. The Remote Configuration and Update function, Barimon and SNMP monitoring,

Web server, IR remote control as well as Priority message stay active in the

Stand-by Mode.

Stand-by Mode can be toggled by the ON/OFF button on the IR remote controller or

externally triggered by issuing the STANDBY or RESUME command (e.g. using the

Remote Configuration and Update function). A typical usage is e.g. in instore

applications during closing-time.

File “remote.ini”

The commands triggered by each button of the IR Remote Control can be user

defined. To upload the altered remote.ini file follow the procedure described in

BARIX AG | 37/63

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 62 63

Comments to this Manuals

No comments

BARIX Streaming Client Installation Guide Page 37

Comments to this Manuals